Are you tired of your prints not sticking together after gluing them? PLA 3D Gloop! is here for you! This incredibly strong adhesive won't let you down. Not only is 3D Gloop! good at being a glue for your prints but it can also work as an adhesion solution on glass or mirrored build surfaces. With a brush already attached to the lid, once you have 3D Gloop! you're ready to start working.
PLA 3D Gloop! comes in a 120ml bottle with a brush already attached.
You can use 3D Gloop! for bed adhesion, print adhesion, and for smoothing out prints during post processing.
For adhering prints together 3D Gloop! forms medium tack bonds within seconds of the bonding surfaces mating and cures to a strong tack within 15 minutes, and takes 30 minutes for a complete strength cure.
To apply to a bed surface or smooth a print out all you need to do is apply even smooth strokes in an alternating fashion. You will have to wait for layers to dry in between coats.
Always use PLA 3D Gloop! in a well ventilated area. PLA 3D Gloop! contains proprietary synthetic ingredients along with strong solvents and stabilizing agents, expert care and caution are required when handling, using, and storing PLA 3D Gloop!
Contents may be under pressure do not open towards you.
Most PEI sheets are compatible with 3D Gloop! but it is strongly recommended to test interactions in a small area or corner of your build platform with your specific printer. DO NOT use 3D Gloop! on any textured print surface as it will likely permanently fuse to it.
The application has encountered an unknown error.
Zoom