Loading...

Cura LulzBot Edition Installation: Debian

Installation Instructions

Download Cura LulzBot Edition by clicking one of the buttons below

Once downloaded, in a terminal navigate to the directory containing the file and send the following command:

sudo dpkg -i cura-lulzbot-3.6.36-deb10-Linux.deb

That's it! Cura LulzBot Edition is setup and ready to use.

Please note: LulzBot Cura for Debian is currently only supported on Debian 10 Buster

Cura LulzBot Edition is a Free Software 3D printing solution offered through our code repositories.

System requirements and the End User License Agreement can be found on LulzBot.com/Cura. 

Trouble Upgrading? Clean Your Cache!

The commands below will delete the older slicing profiles and 3D printer settings from previous versions of Cura LulzBot Edition. Back up the files and folders listed below first if any customizations have been made.

Open a terminal.

Run the following commands:

cd; rm -rf ~/.cache/cura-lulzbot ~/.config/cura-lulzbot ~/.local/share/cura-lulzbot

Troubleshooting

If you have trouble connecting to your LulzBot 3D printer, you may need to add your user account to the dialout/tty serial access group. In a terminal, send the following commands:

sudo usermod -a -G tty $USER
sudo usermod -a -G dialout $USER

​Log out of your current session and once you log in again, you should have port access.

Removal Instructions

Removal through GUI

Synaptic can be installed through terminal, with:

sudo apt-get install synaptic

Launch Synaptic.

Press the Search button found in the upper right hand corner of the Synaptic window.

Type cura into the search box and change the Look in drop down to Name.

Press Search to search for all packages that contain the term cura.

All installed packages with cura will be displayed. De-select the cura-lulzbot package.

Choose either Mark for Removal or Mark for Complete Removal.

Press the Apply Changes button to remove the selected package.

Removal via Terminal

Open a terminal and send one of the following commands, based on your desired outcome.

To remove just the cura package and leave behind any existing cura user data:

sudo apt-get remove cura-lulzbot

To remove the cura package and any dependencies, but do not remove any existing cura user data:

sudo apt-get remove --auto-remove cura-lulzbot

To remove the cura package, any dependencies, and all cura user data:

sudo apt-get purge cura-lulzbot

Alternatively, dpkg can also be used:

sudo dpkg --remove cura-lulzbot
.
A notice about cookies

This website uses cookies. By continuing to browse this site, you agree to their use.

See all options